Bertazzoni REF30PIXL Manuel et guide de l'utilisateur télécharger pdf (Page 13)

Installation Guide

EnglishFrançais

Series: Integrated (BI)

Door and Bottom-Drawer overlay panels layout

The dimensions of the panels are indicated in the table and draw-

ings on pages 13.

Nevertheless, according to the requirements for aligning with other

kitchen structures, the door panel can be higher than the upper

edge of the refrigerator door, and the drawer panel can be lower

than the edge of the drawer.

The panels must be mounted using special braces which attach

to adjustable devices provided on the door and drawer and with

brackets that anchor and adjust the panel’s vertical direction.

Braces, brackets and fixing screws are provided with the appliance

and must be applied to the panel as indicated.

Operate as follows:

To prepare the panels to be mounted on the appliance, follow

these steps, working on the back of the panel.

Door Panel

Draw a reference center line, dividing the panel width in half

Starting from the bottom edge of the panel, mark the positioning

of the brackets

Following the corresponding table, mark the outside and then the

inside hole

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Pas de commentaire

Bertazzoni REF30PIXL Manuel et guide de l'utilisateur Page 13