Bertazzoni KOTR30X Manuel d'installation télécharger pdf (Page 22)

MOUNT THE MICROWAVE

OVEN (cont.)

Installation Instructions

Tighten the outer two screws to the top of the

microwave oven. (While tightening screws, hold

the microwave oven in place against the wall and

the top cabinet.)

Insert 2 self-aligning screws

through outer top cabinet

holes. Turn two full turns on

each screw.

Tighten center

screw completely.

Install grease filters. See the Owner’s Manual

packed with the microwave.

C4.

Charcoal

Filter

#1 Phillips screwdriver.

Open the door.

Remove the grille.

Pull the grille straight off.

NOTE: The charcoal filter is factory installed in

recirculating models. Follow these steps to replace a

filter or to install a filter after converting a vented

model to recirculating operation.

Remove screws on top of grille using a

C5.

INSTALLING OR CHANGE

THE CHARCOAL FILTER





2EPLACETHEGRILLEANDTHESCREWS

#LOSETHEDOOR

)NSERT



)NSTALLTHECHARCOALFILTER)NSERTFILTERUPPER

INTHEUNITANDTHENPULLDOWNFILTER7HEN

PROPERLYINSTALLEDTHEWIREMESHOFTHEFILTER

SHOULDBEVISIBLEFROMTHEFRONT

1 2 ... 17 18 19 20 21 22 23 24

Pas de commentaire

Bertazzoni KOTR30X Manuel d'installation Page 22