Bertazzoni DW24XT Manuel d'installation télécharger pdf (Page 13)

Installation Instructions

Figure Z

STEP 17 REPLACE TOEKICKSTEP 16 DISHWASHER WET TEST

Turn on power supply (or plug power cord into

outlet, if equipped).

Turn on your dishwasher (please refer to the

Owner's Manual for instructions).

Close door, select RINSE ONLY cycle and press

START/CANCEL.

Check to be sure that water enters the dishwasher

If water does not enter the dishwasher, check to be

sure that water and power are turned on.

Check for leaks under the dishwasher. If a leak is

found, turn power supply off, then tighten

connections. Restore power after leak is corrected.

Check for leaks around the door. A leak around the

door could be caused by door rubbing or hitting

against adjacent cabinetry. Reposition the dish-

washer if necessary.

See Step 9.

When the dishwasher is draining, check the drain

lines. If leaks are found, turn power off at the

breaker and correct plumbing as necessary.

Restore power after corrections are made.

See Step 12.

Open dishwasher door and make sure most of the

water has drained. If not, check that disposer plug

has been removed and/or air gap is not plugged.

See Step 13. Also check drain line for kinking.

Run the dishwasher through another ﬁll and drain

cycle. Check for leaks and correct if required.

STEP 18 LITERATURE

Be sure to leave complete literature package and

installation instructions with consumer.

Place 1-piece toekick against the legs of the

dishwasher. The slots should align with toekick

bracket screw holes. Allow the toekick to touch the

floor. Install the toekick screws.

1 2 ... 8 9 10 11 12 13

Pas de commentaire

Bertazzoni DW24XT Manuel d'installation Page 13