Bertazzoni X90 6 MFE X Manuel d'installation

INSTALLATION, MAINTENANCE AND USE INSTRUCTIONS FOR FREE-STANDING COOKERS 90x60 cm (type M91/M91V) Model X906MFE* , X906 DUAL*, X906GEV*

10 - the symbol indicates that the electric fan, and the oven light have been turned on . - the symbol indicates that only the oven light is turn

11- the symbol indicates that only the top external element (1200W) has been turned on; - the symbol indicates the only the bottom element (1800W

12Before cooking, allow the oven to reach the desired temperature setting waiting for the orange light to turn off. This type of oven is equipped wit

13Grilling on the shelf: In this case, the shelf supplied is placed on level 1 or 2 and the foods to be grilled are placed on top, while the tray is

14AFTER-SALES TECHNICAL SERVICE AND SPARE PARTS TECHNICAL SERVICE AND SPARE PARTS Before leaving the factory, this appliance was tested and adjusted

15 Fig. 1 Fig. 3 Fig. 4 Fig. 5 Fig.6

16 Fig.8 Fig.9 Fig.10 Fig.11 Fig 12 Fig 13 Fig. 14

17 Fig 15 Fig. 16 Fig. 17 T Fig. 18

18 Fig. 26 Fig. 27 Fig.28a Fig.28b Fig.28c

19 Fig. 29 Fig. 30 Fig. 31 Fig. 32

2CONTENTS: INSTALLER TECHNICAL MANUAL ...

20OVERALL DIMENSIONS Cod. 310686

3I MPORTANT INFORMATION FOR INSTALLING THE APPLIANCE The cooker can be installed separately, as a freestanding unit, on a plinth (Not suitable for

4This appliance shall be installed only by authorised persons and in accordance with the manufacturer's installation instructions, local gas fit

5WARNING: After completing the above-mentioned replacements, the technician must adjust the burners, as described in the paragraph below, seal any ad

6WARNING: If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avo

7To replace the power cable, lift the terminal board’s cover and replace the cable. To access the terminal board in cookers with a 3x2.5mm² cable, th

8Note: It is recommended not to try to ignite a burner if the relative flame cap is not in the correct position. If the flame does not light after t

9then release the knob. Make sure that the burner remains on, otherwise repeat the operation. As for cookers without ignition trough knob, press the